brochure

M9106-AGx-2N0x Series Electric Non-spring Return Actuators Product Bulletin 3
Dimensions
See Figure 2 for the actuator and differential pressure
transmitter dimensions.
4.0
101.6
1.7
43.2
2.05
52.1
4.2
107.3
2.0
50.8
0.26
6.6
2.15
54.6
2.32
58.9
1.1
28.3
1.00
25.4
5.95
151.2
0.1
2.54
CCW
COM
CW
1.25
31.8
O
U
T
G
N
D
I
N
(
-
)
L
O
4.33
110.0
Note: All dimensions are nominal unless otherwise specified.
D
PT-
2
01
5
Figure 2: M9106-AGS-2N02, in. (mm)
Repairs and Replacement
Field repairs must not be made. For a replacement or
an accessory, refer to the Ordering Information
section.
Ordering Information
Contact the nearest Johnson Controls representative,
and specify the desired product code number from
Table 1 or 2.
Table 1: Actuators
Product Code
Number
Description
M9106-AGA-2N01 Electric actuator
(1-minute rotation time)
M9106-AGA-2N02 Electric actuator
(2-minute rotation time)
M9106-AGS-2N02 Electric actuator (2-minute rotation
time) includes the DPT-2015 and
CBL-2000-1
Table 2: Accessories
Product Code
Number
Description
CBL-2000-1 20 in. (0.5 m) wiring harness, Underwriters Laboratories, Inc.® (UL) accepted for plenum use,
supplied with the M9106-AGS-2N02 and may be ordered separately; connects the M9106 and
DPT-2015 to the VAV controller
CBL-2000-2 20 in. (0.5 m) plenum-rated wiring harness
CBL-2000-3 72 in. (1.8 m) plenum-rated wiring harness
DPT-2015-0 0 to 1.5 in. W.C. (0 to 375 Pa) differential pressure transmitter supplied with the M9106-AGS-2N02
and may be ordered separately
DMPR-KC003 Blade Pin Extension without Bracket supplied with Johnson Controls CD-1300 dampers and may be
ordered separately
DMPR-KR003 Sleeve Pin Kit supplied with Johnson Controls round dampers that have a 5/16 in. (8 mm) shaft and
may be ordered separately
DMPR-KC010* Adjustable Blade Position Indicator Switch Kit with total switching load limited to 2000 VA for the
following applications: Pilot Duty: 24 VAC, 50 VA; 125/250/277 VAC, 125 VA;
Motor Load: 125/250/277 VAC, 1/3 hp; Resistive Load: 125 VAC, 11 A; 250 VAC, 8 A; 277 VAC, 7 A
(all maximum values)
M9000-200 Commissioning Tool provides a control signal to drive on/off, floating, proportional, or
resistive actuators.
* Use with an M9106 actuator to replace an EDA-2040 or ATP-2040 actuator and EDA-2040-102 switch kit.