brochure

ManualsBrandsJohnson Controls ManualsDampersM9106 24 VAC Electric Non Spring Return Actuator w/ 1-min Rotation Time (53 lb-in)

Table Of Contents

Product Bulletin M9106-AGx-2N0x

Issue Date 08/31/01

Code No. LIT-2681126 www.johnsoncontrols.com

M9106-AGx-2N0x Series Electric

Non-spring Return Actuators

The M9106-AGA-2N0x synchronous motor-driven

actuators provide floating (3-wire) control and are

easily installed on a Variable Air Volume (VAV) box.

They may also be installed on a small or medium-sized

damper with a round shaft up to 1/2 inch (13 mm) in

diameter or a 3/8 inch (10 mm) square shaft.

These compact, non-spring return actuators have a

53 lb·in (6 N·m) running torque in a compact

easy-to-install package. The actuators are available

with either a nominal 60-second travel time at 60 Hz

(72 seconds at 50 Hz) or a nominal 120-second travel

time at 60 Hz (144 seconds at 50 Hz) for 90° of

rotation.

The M9106-AGS-2N02 Actuator/Transmitter combines

an M9106-AGA-2N02 with a prewired DPT-2015

Differential Pressure Transmitter that has a 0 to 1.5 in.

W.C. (0 to 374 Pa) differential pressure range.

Figure 1: M9106-AGS-2N02 Non-spring

Return Actuator

Features and Benefits

❑

35 dBA Rating Meets audible requirements for open ceilings

❑

Synchronous Drive Provides constant rotation time independent of

load

❑

Direct Shaft Mount with

Single-screw Coupler

Simplifies installation and provides 3-point

shaft gripping

❑

Magnetic Clutch Provides torque protection for the actuator and

damper

❑

Adjustable Rotation Stops Allow application versatility with 30 to 90°

Clockwise (CW) or Counterclockwise (CCW)

rotation

❑

Manual Gear Release Simplifies setup and field adjustments

❑

Screw Terminal Connection Makes wiring easy

Summary of content (4 pages)

PAGE 1
Product Bulletin Issue Date M9106-AGx-2N0x 08/31/01 M9106-AGx-2N0x Series Electric Non-spring Return Actuators The M9106-AGA-2N0x synchronous motor-driven actuators provide floating (3-wire) control and are easily installed on a Variable Air Volume (VAV) box. They may also be installed on a small or medium-sized damper with a round shaft up to 1/2 inch (13 mm) in diameter or a 3/8 inch (10 mm) square shaft.
PAGE 2
Application IMPORTANT: This device is not designed or intended to be used in or near environments where explosive vapors or gases could be present, or environments where substances corrosive to the device’s internal components could be present. The actuators are used to position balancing, control, round, and zone dampers in typical Heating, Ventilating, and Air Conditioning (HVAC) applications. They are also used to position the blades in a VAV box.
PAGE 3
Dimensions Repairs and Replacement See Figure 2 for the actuator and differential pressure transmitter dimensions. Field repairs must not be made. For a replacement or an accessory, refer to the Ordering Information section. 4.0 101.6 1.7 43.2 1.25 31.8 Ordering Information Contact the nearest Johnson Controls representative, and specify the desired product code number from Table 1 or 2. 5.95 151.2 -2 01 5 LO (-) 4.33 110.
PAGE 4
Technical Data Product M9106-AGx-2N0x Series Electric Non-spring Return Actuators M9106-AGA-2N01: M9106-AGx-2N02: DPT-2015: 24 VAC (20 to 30 VAC) at 50/60 Hz, 2.5 VA supply, Class 2 24 VAC (20 to 30 VAC) at 50/60 Hz, 2.1 VA supply, Class 2 15 VDC (14.