Brochure

EP-8000 Series Electro-Pneumatic Transducers Product/Technical Bulletin
4
To mount an EP-8000 on a pneumatic valve actuator,
the EP-8000-101 Mounting Kit (ordered separately)
must be used. The EP-8000, in conjunction with the
EP-8000-101, can be mounted on the following
actuators: 4R, 5R, 8R, V-400, V-500, or V-3000-1
Series Valve Actuator with or without a V-9502 Valve
Actuator Positioner. (See Figure 8.) It can also be used
with a V-3000-8001 Series Valve Actuator with or
without a V-9502. (See Figure 9.)
Panel Mounting
Mount the EP-8000 on a flat, vibration-free surface,
using the following steps:
1. Mark two mounting slots on the mounting surface
using the integral mounting bracket as a template.
2. Drill a pilot hole at each of the marked locations.
3. Secure the EP-8000 in place using the two No. 8
screws provided.
Figure 8: EP-8000-101 Mounting Kit for Installation of the EP-8000 to
a 4R, 5R, 8R, V-400, V-500, and V-3000-1 Valve Actuator With or
Without a V-9502 Positioner
V-3000-1
Mounting Detail
Figure 9: EP-8000-101 Mounting Kit for Installation of the EP-8000 to a
V-3000-8001 Valve Actuator With or Without a V-9502 Positioner
Mounting
Bracket
Screws (2)