Product Overview

EP-8000 Series Electro-Pneumatic Transducers Product/Technical Bulletin 3
D
imensions
5°
5°
Wirin
g
Entr
y
Slot
Two Mountin
g
Slots
for No. 8 3/8 in.
Slotted Pan-head
Sheet Metal Screws
H
y
podermic
Needle
Test Point
Zero
Ad
j
ustment
Screw
2-11/32
60
1-29/32
48
1-25/32
45
1-1/2
38
3-11/32
85
2
51
Figure 6: EP-8000 Low-volume Output Model
Dimensions (in./mm)
2-13/32
61
4-1/4
108
5°5°
1-25/32
45
Wirin
g
Entr
y
Slot
SO
2-11/32
60
1-29/32
48
2
51
Output Air
Connection
Suppl
y
Air
Connection
Zero
Ad
j
ustment
Screw
Two Mountin
g
Slots
for No. 8 3/8 in.
Slotted Pan-head
Sheet Metal Screws
H
y
podermic
Needle
Test Point
Figure 7: EP-8000 High-volume Output Model
Dimensions (in./mm)
I
nstallation
Parts Included
• EP-8000 Transducer
• No. 8 3/8 in. sheet metal screws (2)
Tools Needed
• flat-blade screwdrivers, 3/32 in. and 1/4 in.
• 5/32 in. drill bit and drill
M
ounting
Regardless of the mounting method chosen, the
EP-8000 must be mounted within 5° of vertical for
proper operation. (Refer to Figures 6 and 7.) In most
cases, the vertical position of the EP-8000 can be
obtained by correctly positioning the transducer’s
mounting bracket and/or angle bracket. Do not mount
an EP-8000 directly to a damper actuator.
To mount an EP-8000 on a pneumatic valve actuator,
the EP-8000-101 Mounting Kit (ordered separately)
must be used. The EP-8000, in conjunction with the
EP-8000-101, can be mounted on the following
actuators: 4R, 5R, 8R, V-400, V-500, or V-3000-1
Series Valve Actuator with or without a V-9502 Valve
Actuator Positioner. (See Figure 8.) It can also be
used with a V-3000-8001 Series Valve Actuator with or
without a V-9502. (See Figure 9.)
Panel Mounting
Mount the EP-8000 on a flat, vibration-free surface,
using the following steps:
1. Mark two mounting slots on the mounting surface
using the integral mounting bracket as a template.
2. Drill a pilot hole at each of the marked locations.
3. Secure the EP-8000 in place using the two No. 8
screws provided.