Brochure

Table Of Contents
The performance specifications are nominal and conform to acceptable industry standards. For applications at conditions beyond these specifications, consult the local Johnson Controls office.
Johnson Controls, Inc. shall not be liable for damages resulting from misapplication or misuse of its products. © 2015 Johnson Controls, Inc. www.johnsoncontrols.com
R-214
System 450™ Expansion Modules with Analog Output
Code No. LIT-1900659
Description
System 450 expansion modules allow you to increase the number of
outputs in your control system to meet your application requirements.
The following models are available:
C450SPN-1C: Analog Expansion Module with one analog output
(each 0 to 10 VDC or 4 to 20 mA)
C450SQN-1C: Analog Expansion Module with two analog outputs
(each 0 to 10 VDC or 4 to 20 mA)
Refer to the following documents for important product application
information:
System 450™ Series Modular Controls Product Bulletin
(LIT-12011458)
System 450™ Series Expansion Modules with Analog Outputs
Installation Instructions (Part No. 24-7664-2799)
Features
Durable, compact, interchangeable modular components with
plug-together connectors and DIN rail or direct wall mount capability
eliminate field wiring between modules and allow you to quickly and
easily design, assemble, install, and upgrade your control systems.
Versatile, multipurpose, field-configurable control modules and
expansion modules designed for global use allow you to create a
wide variety of application-specific control systems capable of
controlling temperature, pressure, or humidity, or all three
conditions simultaneously, with only a small suite of module models.
Up to three hard-wired input sensors and up to ten relay or analog
outputs (in any combination) per control system allow you to build
complex custom control systems while reducing your control system
cost to only the cost of the required components.
C450SQN-1C Expansion Module with Analog Output
Selection Chart
Product Code
Number
Product Description
C450SPN-1C Analog Output Expansion Module; provides one analog output (0 to 10 VDC or 4 to 20 mA self-selecting signal) for proportional control.
C450SQN-1C Analog Output Expansion Module; provides two analog outputs (0 to 10 VDC or 4 to 20 mA self-selecting signals) for proportional control.
BKT287-1R DIN Rail; 0.30 m (12 in.) long
BKT287-2R DIN Rail; 1 m (39-1/3 in.) long
BKT287-3R DIN Rail; 0.61 m (24 in.) long
BKT287-4R DIN Rail; 0.36 m (14 in.) long
PLT344-1R DIN Rail End Clamps (Two clamps)
WHA-C450-100C System 450 module connection extension cable, 100 cm (3.3 ft) long
System 450 Control Series
Repair Information
If the System 450™ Expansion Module with Analog Output fails to
operate within its specifications, replace the unit. For a replacement
System 450™ Expansion Module with Analog Output, contact a
Johnson Controls® representative.