User Manual

necessary to follow steps 5-7 of the “Programming” section to complete the rolling code
training. This procedure will not affect any other programmed HomeLink buttons.
Erasing Programmed HomeLink® Buttons
Press and hold the two outer HomeLink buttons releasing only when the HomeLink
indicator light begins to flash after 20 seconds. Do not hold for longer than 30 seconds.
HomeLink is now in the train (or learning) mode and can be programmed at any time
beginning with step 2 in the “Programming” section of this text.
Accessories
If you would like additional information on the HomeLink® Wireless Control System,
HomeLink compatible products or to purchase accessories, please contact HomeLink at
1-800-355-3515 or visit our website at www.homelink.com
.
This device complies with FCC rules part 15. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any
interference that may be received including interference that may cause undesired operation.
WARNING: The transmitter has been tested and complies with FCC and IC rules. Changes or
modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the device.
The term “IC:” before the certification/registration number only signifies that Industry Canada
technical specifications were met.
IC: 279B-WLHL4 JCI MODEL/FCC ID: CB2WLHL4
HomeLink and the HomeLink house are registered trademarks of Johnson Controls, Inc.