User's Manual

Introduction

The Hands Free Module (HFM) is a Bluetooth

™

device that allows for wireless communication

with other Bluetooth devices. Bluetooth wireless technology is a high frequency radio link that

allows two Bluetooth devices to exchange audio information and data at high speed. Because of

the versatility of Bluetooth wireless technology, enabled devices do not share all of the same

"profiles." To ensure that your phone will be compatible with your HFM, be sure to purchase a

cellular phone that supports the "Dial-up Networking" profile.

Precautions

Warning: When preparing to set up the HFM, be sure the vehicle involved is in park with the

engine turned off.

Setting up Your HFM

Note: Most vehicles require the ignition switch to be turned to the second (or "accessory")

position for programming and/or operation of the HFM. The radio must be turned on to hear

HFM audio. It is also recommended that your cell phone's battery be fully charged to ensure that

the Bluetooth connection will be established with minimal difficulty. To use the voice

recognition software, face the windshield and speak clearly in your normal voice (do not shout).

Note: The voice recognition software expects you to speak in a natural voice. Do not try to

"help" the voice recognition software by speaking slowly or by pronouncing words more

distinctly than you normally do.

Pairing

In order for your HFM to work with your Bluetooth phone, you must first pair the two devices.

To pair a phone to HFM:

1. Press and release HFM's Phone button.

2. After you hear the "Ready" prompt, say "Setup, Registration."

3. The HFM will prompt, "Do you want to register a phone, clear a phone, or list available

phones?" Say "Register."

4. Refer to your cellular phone user's manual for further information on pairing your phone to

HFM.

Clearing Paired Phones

To re-prioritize the cell phones being used, you must first clear the phone(s) paired with HFM.

Note: If you make a mistake during the clearing process or decide not to clear a phone, press

either HFM's Phone button or VR button to exit the clearing mode.

To clear paired cell phones from the HFM's memory:

1. Press and release HFM's Phone button.

2. After you hear the "Ready" prompt, say "Setup, Registration."