User Manual

JOBNAME: CHRY OM (Contenta pu PAGE: 5 SESS: 1 OUTPUT: Tue Jan 3 09:31:46 2012 SUM: 1A86A505

/chry_pdm/chrysler/owners/ctx/sim03.40.00

2. Place the hand-held transmitter 1 to 3 inches (3 to

8 cm) away from the HomeLinkt button you wish to

program.

3. Simultaneously press and hold both the Homelinkt

button you want to program and the hand-held transmit-

ter button.

4. Continue to hold buttons until the EVIC display

changes from “CHANNEL # TRAINING” to “CHAN-

NEL # TRAINED”, then release both buttons.

NOTE:

•

It may take up to 30 seconds or longer in some cased

for the channel to train.

•

If the EVIC displays “DID NOT TRAIN” repeat from

Step 2.

5. Press and hold the programmed HomeLinkt button.

The EVIC will display “CHANNEL # TRANSMIT”. If the

garage door opener/device activates, programming is

complete.

To program the remaining two HomeLinkt buttons,

repeat each step for each remaining button. DO NOT

erase the channels.

Reprogramming A Single HomeLinkt Button

To reprogram a channel that has been previously trained,

follow these steps:

1. Turn the ignition switch to the ON/RUN position.

2. Press and hold the desired HomeLinkt button until

the EVIC displays “CHANNEL # TRAINING” Do not

release the button.

3. Without releasing the button proceed with “Program-

ming A Non-Rolling Code” Step 2 and follow all remain-

ing steps.