User Manual

JOBNAME: CHRY OM (Contenta pu PAGE: 3 SESS: 1 OUTPUT: Tue Jan 3 09:31:46 2012 SUM: 1C395F54

/chry_pdm/chrysler/owners/ctx/sim03.40.00

1. Turn the ignition switch to the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 inches (3 to

8 cm) away from the HomeLinkt button you wish to

program.

3. Simultaneously press and hold both the Homelinkt

button you want to program and the hand-held transmit-

ter button.

4. Continue to hold buttons until the EVIC display

changes from “CHANNEL # TRAINING” to “CHAN-

NEL # TRAINED”, then release both buttons.

NOTE:

•

It may take up to 30 seconds or longer in some cased

for the channel to train.

•

If the EVIC displays “DID NOT TRAIN” repeat from

Step 2.

5. At the garage door opener motor (in the garage),

locate the “LEARN” or “TRAINING” button. This can

usually be found where the hanging antenna wire is

attached to the garage door opener/device motor. Firmly

press and release the “LEARN” or “TRAINING” button.

Training The Garage Door Opener

1 — Door Opener

2 — Training Button

art=034000356.tif NO TRANS