User Manual

JOBNAME: CHRY OM (Contenta pu PAGE: 2 SESS: 1 OUTPUT: Tue Jan 3 09:31:46 2012 SUM: 23A213ED

/chry_pdm/chrysler/owners/ctx/sim03.40.00

For more efficient programming and accurate transmis-

sion of the radio-frequency signal it is recommended that

a new battery be placed in the hand-held transmitter of

the device that is being programmed to the HomeLinkt

system.

Erase all channels before you begin programming. To

erase the channels place the ignition in the ON/RUN

position and press and hold the two outside HomeLinkt

buttons (I and III) for up 20 seconds. The Electronic

Vehicle Information Center (EVIC) will display “CLEAR-

ING CHANNELS”. Release the buttons when the EVIC

displays “CHANNELS CLEARED”.

NOTE:

•

Erasing all channels should only be performed when

programming HomeLinkt for the first time. Do not

erase channels when programming additional buttons.

•

If you have any problems, or require assistance, please

call toll-free 1–800–355–3515 or, on the Internet at

www.HomeLink.com for information or assistance.

Programming A Rolling Code

For programming garage door openers that were manu-

factured after 1995. These garage door openers can be

identified by the “LEARN” or “TRAIN” button located

where the hanging antenna is attached to the garage door

opener. It is NOT the button that is normally used to

open and close the door. The name and color of the

button may vary by manufacturer.