User Manual

JOBNAME: CHRY OM (Contenta pu PAGE: 13 SESS: 1 OUTPUT: Tue Jan 3 09:31:46 2012 SUM: 2310549F

/chry_pdm/chrysler/owners/ctx/sim03.40.00

NOTE: You have 30 seconds in which to initiate the next

step after the LEARN button has been pressed.

6. Return to the vehicle and press the programmed

HomeLinkt button twice (holding the button for two

seconds each time). If the garage door opener/device

activates, programming is complete.

NOTE: If the garage door opener/device does not

activate, press the button a third time (for two seconds) to

complete the training.

To program the remaining two HomeLinkt buttons,

repeat each step for each remaining button. DO NOT

erase the channels.

Reprogramming A Single HomeLinkt Button

To reprogram a channel that has been previously trained,

follow these steps:

1. Turn the ignition switch to the ON/RUN position.

2. Press and hold the desired HomeLinkt button until

the indicator light begins to flash after 20 seconds. Do not

release the button.

3. Without releasing the button proceed with “Program-

ming A Rolling Code” Step 2 and follow all remaining

steps.

Programming A Non-Rolling Code

For programming Garage Door Openers manufactured

before 1995.

1. Turn the ignition switch to the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)

away from the HomeLinkt button you wish to program

while keeping the HomeLinkt indicator light in view.

3. Simultaneously press and hold both the Homelinkt

button you want to program and the hand-held transmit-

ter button.