User Manual

JOBNAME: CHRY OM (Contenta pu PAGE: 12 SESS: 1 OUTPUT: Tue Jan 3 09:31:46 2012 SUM: 24986E04

/chry_pdm/chrysler/owners/ctx/sim03.40.00

1. Turn the ignition switch to the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)

away from the HomeLinkt button you wish to program

while keeping the HomeLinkt indicator light in view.

3. Simultaneously press and hold both the Homelinkt

button you want to program and the hand-held transmit-

ter button.

4. Continue to hold both buttons and observe the indi-

cator light. The Homelinkt indicator will flash slowly

and then rapidly after Homelinkt has received the fre-

quency signal from the hand-held transmitter. Release

both buttons after the indicator light changes from slow

to rapid.

5. At the garage door opener motor (in the garage),

locate the “LEARN” or “TRAINING” button. This can

usually be found where the hanging antenna wire is

attached to the garage door opener/device motor. Firmly

press and release the “LEARN” or “TRAINING” button.

On some garage door openers/devices there may be a

light that blinks when the garage door opener/device is

in the LEARN/TRAIN mode.

Training The Garage Door Opener

1 — Door Opener

2 — Training Button

art=034000356.tif NO TRANS