Installation Manual



InstallationManual

Themoduleisinstalledwhilethecarisbeingbuilt.

Moduleisscrewedintotopofplasticbincoverwith2TorxHeadscrews.Harnessispluggedinto

Module.



RadioharnessispluggedintobackofRadio.RadioismountedintoInstrumentPanelwith4screws.



RadioFacePlateharnessisconnectedtoRadioFacePlate.RadioFaceplateissnappedintoplace.



PAGE 1
Installation Manual The module is installed while the car is being built. Module is screwed into top of plastic bin cover with 2 Torx Head screws. Harness is plugged into Module. Radio harness is plugged into back of Radio. Radio is mounted into Instrument Panel with 4 screws. Radio Face Plate harness is connected to Radio Face Plate. Radio Faceplate is snapped into place.
PAGE 2
Vents are snapped into place. Radiofrequency radiation exposure Information: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter. NOTICE: This device complies with Part 15 of the FCC Rules and with RSS‐210 of Industry Canada.
PAGE 3
    Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.