User's Manual

PSI Operational Description
This system monitors the tire pressure for each of the tires on the car. It provides basic tire pressure
information and warning messages to the driver when the tire pressure is too high or too low. It also
provides warning messages when the system is not functioning properly. A tire pressure sensor in each
wheel will broadcast a radio frequency tire pressure signal with a unique ID and tire pressure status to the
receiver in the EVIC. The PSI system analyzes this information based on the unique ID from the
message, it determines which tire has sent the information. This tire pressure information is then
displayed on the EVIC display in such a way as to indicate if a tire has a low or high pressure. Pertinent
warning messages will be displayed if any of the tire pressures go too low or too high. In addition, if the
tire pressure sensor transmitter battery voltage starts to go too low in the transducers or if they are not
operating properly then messages displaying these warnings will be displayed on the EVIC display.
PSI Train Mode of Operation
In order for the system to know which tire relates to which pressure transducer, it is necessary to train the
system after installation of tires and after any tire rotation or change. To train the PSI system place the
ignition in the RUN position and then press the MENU button on the EVIC until the display says “Retrain
Tire Sensors”, at this point press the STEP button until the option “YES” is displayed. The EVIC will
display which tire needs to be trained first. Proceed to that tire and place either a magnet or a 125 kHz
transponder within close proximity to the pressure transducer on that tire. When the tire is trained the
PSI system will cause the vehicle to provide a single horn chirp. At this point, proceed to the next tire,
which is indicated by the display on the EVIC. Repeat this process for each of the tires.