User's Guide Part 2

5
86
Interior Features
Bluetooth
®
Device selection
If several devices have been programmed,
the Bluetooth
®
unit links the device last
programmed. If you would like to link
a different programmed device, it is
necessary to change the link. The order
of device priority after the link has been
changed is maintained even when the
ignition is switched off.
1. Using the audio control dial, select the
link change mode “ LINK CHANGE
in the “ BT SETUP ” mode. (Refer to
“Bluetooth
®
audio device set-up” for
details.)
2. Press the audio control dial to
determine the mode.
3. The name of the currently linked
Bluetooth
®
audio device is displayed.
If no Bluetooth
®
audio device is
currently linked, the name of the rst
device among the programmed devices
is displayed.
4. Turn the audio control dial to select the
name of the device you would like to
link.
Device name 1
Device name 2
Device name 3
Device name 4
Device name 5
Device name 6
Device name 7
5. Press the audio control dial to select the
device you would like to link. The
symbol disappears, and “ PAIRING
ashes in the audio display.
NOTE
When “ GO BACK ” is selected and the
audio control dial is pressed, the display
returns to “ LINK CHANGE ”.
6. If the link to the desired device is
successful, the
symbol is displayed
again, together with “ LINK
CHANGED ” “ LINK CHANGED ” is
displayed for three seconds, then it
returns to the normal display.
NOTE
Some Bluetooth
®
audio devices need a
certain amount of time before the
symbol is displayed.
If a hands-free type mobile phone has
been the most recently programmed
device, the Bluetooth
®
unit links this
device. If you would like to use a
Bluetooth
®
audio type device which
has been previously programmed to
the Bluetooth
®
unit, the link must be
changed to this device.
If an error occurs while trying to link
a device, “ Err ashes in the audio
display for three seconds, and the
display returns to “ LINK CHANGE
If this occurs, check the programming
status of the Bluetooth
®
audio device
and the location of the device in
the vehicle (not in the trunk or a
metal-type box), and then try the link
operation again.
Device selection can also be done
using voice recognition.
Mazda3_8CX9-EA-13F_Edition1.indb 86Mazda3_8CX9-EA-13F_Edition1.indb 86 2013/05/17 11:51:022013/05/17 11:51:02