User's Guide Part 1

3 – 14
Before Driving
Doors and Locks
NOTE
• The system can be set to unlock
all doors by performing a single
operation.
Refer to Personalization Feature on
page 9-10 .
Use the following procedure to change
the setting.
1. Switch the ignition off and close all
of the doors and the liftgate/trunk
lid.
2. Open the driver's door.
3. Within 30 seconds of opening the
driver's door, press and hold the
UNLOCK button on the key for 5
seconds or longer. The sound of
the doors locking/unlocking can be
heard.
After this, the system switches the
setting of pressing the driver's
request switch once or twice to
unlock all doors and the liftgate/
trunk lid each time the UNLOCK
button is pressed (the sound of the
doors locking/unlocking can be
heard).
4. The setting change is completed by
doing any one of the following:
• Switching the ignition to ACC or
ON.
•
Closing the driver's door.
•
Opening the liftgate/trunk lid.
•
Not operating the key for 10
seconds.
•
Pressing any button except the
UNLOCK button on the key.
•
Pressing a request switch.
• Confi rm that all doors and the
liftgate/trunk lid are securely locked.
For the liftgate/trunk lid, move it
without pressing the electric liftgate/
trunk lid opener to verify that the
liftgate/trunk lid has not been left
ajar.
•
All doors and the liftgate/trunk lid
cannot be locked when any door or
the liftgate is open.
•
It may require a few seconds for the
doors to unlock after the request
switch is pressed.
•
A beep sound is heard for
confi rmation when the doors and the
liftgate/trunk lid are locked/unlocked
using the request switch. If you
prefer, the beep sound can be turned
off. The volume of the beep sound
can also be changed.
Refer to Personalization Feature on
page 9-10 .
Use the following procedure to
change the setting.
1. Switch the ignition off and close all
of the doors and the liftgate/trunk
lid.
2. Open the driver's door.
Mazda3_8CX9-EA-13F_Edition1.indb 14Mazda3_8CX9-EA-13F_Edition1.indb 14 2013/05/17 11:48:582013/05/17 11:48:58