User's Manual

Reprogramming a Single HomeLink Button
To program a device to HomeLink using a HomeLink button previously trained, follow these
steps:
1. Press and hold the desired HomeLink button. DO NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the
HomeLink button, proceed with “Programming” - step 1
For questions or comments, contact HomeLink at: www.homelink.com
or 1–800–355–3515.
This device complies with FCC rules part 15 and Industry Canada RSS-210. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference that may be received including interference that
may cause undesired operation. WARNING: The transmitter has been tested and complies with
FCC and IC rules. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the device.
The term “IC:” before the certification/registration number only signifies that Industry Canada
technical specifications were met.
IC: 279B-
51AHL4NR JCI MODEL: 51AHL4NR FCC ID: CB251AHL4NR
HomeLink and the HomeLink house are registered trademarks of Johnson Controls, Inc.