GoBoard Install Guide

4
2
1
3
How to Measure & Cut GoBoard
Measure for the first board placement, and with your pen or pencil, mark
where you need to cut it to fit. For big tiling areas, you will have pieces of
GoBoard that you won’t need to cut.
For every piece of GoBoard you need to cut, simply:
1
Lay it on any flat and durable surface, and draw your cut line using a straight edge
(like a ruler) to ensure a straight cut
2
To score, cut through outer facing with a utility knife along your measured line
3
To snap, bend the board at the edge of the surface, and quickly apply downward
pressure at the scored line, snapping GoBoard along the cut line
Alternate method:
• After scoring with your utility knife, stand the board on edge
• Place your knee against the back of the board, directly behind the scored line
• Bend the board backward against your knee
For circular cuts:
• Use this method for GoBoard going around pipe holes, drain cutouts or around the sink
• Use a ruler to measure a circle:
- Draw a dot in the middle of the circle to be cut
- Mark additional dots the same distance around to form the area that you need to cut
• Cut GoBoard completely through with a utility knife
• Pop the cut piece out with your fist, hammer or other tool