Product Manual

OPERATOR’S MANUAL FC-P30A-UL-D
4.
OPERATION
STORAGE
1. Disconnect supply air when not in use.
2
. Always place the valve in the “OFF” position when not in
use.
3. Wrap and store the hose on the provided hose wrap brack-
et.
4. Wrap and store the ground wire on the provided wire wrap
b
racket.
5. Locate the park the Diesel Caddy on a flat level surface,
away from any potential ignition sources, away from any
potential hazards that may impact or damage the Diesel
Caddy.
6. Lock wheel brakes.
7. Be certain that the fuel gage vent dome, indicator cap, fill
tube and fill tube cap are all present and secure. Replace
any missing parts immediately.
Fig. 3
PRODUCT SPECIFICATIONS
Weight (empty): 154 lbs (69.5 kgs.)
Capacity: 30 gal (114 L)
Length: 31.25” (76 cm)
Width: 25.0” (88.9 cm)
Height: 39.50” (100.5 cm)
Approx. Flow: 7 gpm (26 L pm) @ 40 PSI
PUMPING FROM DIESEL CADDY TO VEHICLE
1. Position the Diesel Caddy near the vehicle and lock the
wheel brakes.
2. Attach the ground wire clamp to the vehicle to a known
ground surface.
3. Place the hose inside the fill pipe of the vehicle fuel tank.
4. Align valve handle so that the point is position to the “OUT”
to vehicle position. (See Fig. 3)
5. Connect shop air supply. WARNING: AIR SUPPLY MUST
NOT EXCEED 120 PSI.
6. Squeeze the air throttle valve to operate pump. Closely
monitor flow to prevent overfilling or spilling.
7. Release valve when desired amount is pumped.
8. Turn the valve to the “IN” to tank position.
9. Uncoil and raise the hose and briefly run the pump to return
any remaining fuel in the system to the tank.
10.Coil and hang the hose on the hanger bracket.
11.Turn valve handle to the “OFF” position.
OPERATOR’S MANUAL FC-P30A-UL-D
5.
REPLACEMENT FILTERS
Fuel Type Filter Type Part No.
Unleaded Gasoline 10 micron 10M-FF
Diesel/Kerosene 30 micron 30M-FF
Note:Coat the O-ring seal with oil or grease before assembly. Hand tighten by
turning approximately 1/2 turn after rubber seal contacts the filter support. Do
not over-tighten.
REPLACEMENT PARTS:
Item Description Qty Part No.
1 Tank 1 _____
2 Handle 1 30GC-02C
3 Cover 1 30GC-49-UL
4 Wheel (10”) 2 30GC-UL
5 Caster (5”) 2 30GC-48
6 Fuel Gage (cap/nut) 1 30GC-FGK
7 Fuel Gage (complete) 1 FC-P30-FG
8 Vent 1 30GC-08-VENT
9 Fill Tube 1 30GC-09-01
10 Fill Cap 1 30GC-09-02
11 Hose Assembly 1 80-593-NI
12 Ground Strap 1 80-572
13 Valve/Filter Support Asm. 1 FC-P30-VALVE
14 ARO Diaphragm Pump
(UL Listed) 1 670042
15 Air Throttle Valve 1 FC-AT
16 Filter/Regulator 1 P391246000
17 Contents Decal Set 1 25GC-04
18 Hose Bracket 1 30GC-46
19 Ground Wire Bracket 1 30GC-47
20 Hose Kit (3 Hoses) 1 FC-P30A-HK
Replacement Parts & Accessories
1
2
10
6
8
13
3
9
4
11
18
15
19
12
14
16
5
17
20
Not Shown