Installation Guide

6
STEP 5 - Installing Secondary Shelves
1. Lower hang shelf is created using a 4 ft. shelf.
2. Long hang is created by cutting a 6 ft. shelf to 21.75 in. wide. (If your
closet is greater or less than 8 ft. wide you will cut your shelf greater
or less that distance.)
3. Mark L clip hardware locations for secondary shelves.
• It is recommended to install hardware into wall studs. Typically 16 in.
on center. Use 50 lb. wall anchors provided if no stud is present.
• Space L-clip hardware equidistant in the following manner:
4-5 L-clip hardware per 6 ft. shelf span
3-4 L-clip hardware per 4 ft. shelf span
2 L-clip hardware per 2 ft. shelf span
4. Center the top screw hole of the shelf mounting L-clip hardware with the
level line & mark all hole locations.
5. Secure L-clip to wall using #8 1 1/2 in. screws at hole locations (Use wall
anchors provided if no stud is present).
6. Repeat for all L-clips at shelf height location.
7. Position shelf end template onto side wall.
8. Align template line with adjacent wall line.
9. Level template.
10. Mark required Shelf End position for required depth (12in. or 16in. depth).
11. Secure Shelf End using #8 - 1 1/2in. screws (use wall anchor if no stud is
present).
19
22
23
20
23
21
3
5
5 6
4
7 8
9 10
11 11
1
2