Installation Guide

3
IMPORTANT - Read Before Assembly
12 in. deep Premier Organizer and 16 in. deep Deluxe Organizer
use the same assembly instruction process EXCEPT DURING
THE J-HOOK PLACEMENT ON THE ANGLE BRACKET.
Assembly instructions are written for 8 ft. conguration A.
All assembly processes are the same for each conguration
EXCEPT for the order or locations of the assembly process.
Use selected conguration for shelf locations.
Shelf lengths and Garment bars may need to be cut depending upon conguration
desired.
All cut shelf lengths are used in closet congurations supplied. Depending upon
your closet dimensions, some cut lengths may not be usable.
EXAMPLE: If you choose an 8 ft. closet conguration and the width of your
closet is 8 ft. 4 in., the cut shelf length will be short 4 in. for use. It is recommended
that if your closet is over the selected dimension (8 ft.), then choose a congura-
tion from the next dimension higher (10 ft.).
EXAMPLE: If you choose an 8 ft. closet conguration and the width of your
closet is 7 ft. 6 in., some shelf lengths may need to be cut 6 in. shorter in length
to t closet dimensions.
VERIFY SHELF MEASUREMENTS
MEASURE - MARK - MEASURE AGAIN
Chosen conguration may not require use of all hardware or components sup-
plied.
It is recommended to secure hardware into wall studs for overall strength and
stability of closet system.
If choosing a custom designed conguration, modications to the instructions pro-
vided will be necessary.
All congurations provided may be reversed.
STEP 1 - Determining Your Dimensions
1. Locate your desired conguration (Instructions are written for 8 ft.
conguration A).
2. Top hang shelf is created with 1 - 6 ft. shelf length.
3. Double hang is created by cutting a 4 ft. shelf to 45.5 in. wide.
4. Long hang is created by cutting a 6 ft. shelf to 24 in. wide. (If your closet
is greater or less than 8 ft. wide you will cut your shelf greater or
less that distance. EXAMPLE: Closet is 8 ft. 5 in. - cut shelf 2 ft. 5 in.
EXAMPLE: Closet is 7 ft. 10 in. - cut shelf 1 ft. 8 in.)
STEP 2 - Marking Measurements On Wall
1. Locate the 3 main shelf height locations for your conguration.
2. Measure up from the oor & mark the 84 in. location.
3. Measure down 42 in. from the 84 in. mark & mark the 42 in. location.
4. Measure down 12 in. from the 84 in. mark & mark the 72 in. location.
84 in. - top shelf
42 in. - double hang shelf
72 in. - long hang shelf
5. Draw a 6 ft. long level line out from wall end at 84 in. location.
6. Draw a 4 ft. long level line out from wall end at 42 in. location.
7. Draw a 2 ft. long level line out from wall end at 72 in. location.
8. Locate stud locations at level lines.