Installation Guide
9
4. DOUBLE CHECK MEASUREMENTS PRIOR TO CUTTING BARS
5. Measure required dimension, mark & cut bar (if necessary).
6. Repeat for all bars.
7. Insert bar end into end of garment bar.
8. Turn clockwise to tighten & repeat for each bar end.
9. Place garment bar onto J-hooks.
10. Secure garment bar to J-Hooks using #6 1 1/4 in. self tapping screws.
11. Repeat for all garment bar locations.
STEP 8 - Installing Adjustable Shelves
1. Select a 24 in. adjustable shelf
2. Insert shelf pin into shelf at hole location.
3. Repeat at each hole location.
4. Place the shelf into the tower by inserting the pins into the tower grooves.
5. Create a shoe shelf by inserting the shelf upside down with the back one
groove higher than the front.
STEP 7 - Installing Garment Bars
1. Locate the bar dimensions in you conî‚¿guration guide
2. The double hang garment bars are created by using 2 - 4ft. bars.
3. The long hang garment bar is created by cutting a bar to 21 in. wide (The
required distance may vary based on actual closet dimensions)
4
4
7
7
8
8
9
10
11
11
2 3
4 4
5
2 3