Installation Guide
10
Creating Adjustable Shelves
Put your excess cuts back into your closet. Any material greater than 24 in.
wide can be used as an additional shelf.
Cut excess lengths to 24 in. wide to use as tower shelves & place where
ever you choose.
In an 8 ft. closet conīguration your 4 ft. of excess shelving can create 2
additional adjustable shelves.
1. Measure required dimension, mark & cut shelf (if necessary).
2. Place shelf end bracket onto shelf.
3. Using the lower hole location on the bracket, drill a pilot hole using a 1/8 in.
drill bit.
4. Remove the shelf end bracket.
5. Re-drill hole 1 - 1 1/4 in. deep using a 1/4 in. drill bit.
6. Repeat steps for each shelf end.
7. Insert shelf pin into holes at each end.
STEP 9 - Final Touches
1. Insert mushroom caps into all angle brackets.
2. Insert mushroom caps into barrel nut holes on tower sides.
3. Touch up scratches & cut ends with stain pen provided.
1
2
3
4
5
7
1 2
3