User manual

Safety Instructions
Installation
Warning! Only a qualified
person must install this
appliance.
Remove all the packaging.
Do not install or use a damaged appliance.
Obey the installation instruction supplied with
the appliance.
Always be careful when you move the appliance
because it is heavy. Always wear safety gloves.
Make sure the air can circulate around the
appliance.
Wait at least 4 hours before connecting the
appliance to the power supply. This is to allow
the oil to flow back in the compressor.
Do not install the appliance close to radiators
or cookers, oven or hobs.
The rear of the appliance must stand against the
wall.
Do not install the appliance where there is
direct sunlight.
Do not install this appliance in areas that are
too humid or too colds, such as the
construction appendices, garages or wine
cellars.
When you move the appliance, lift it by the
front edge to avoid scratching the floor.
Electrical connection
Warning! Risk of fire and
electrical shock.
The appliance must be earthed.
All electrical connections should be made by a
qualified electrician.
Make sure that the electrical information on the
rating plate agrees with the power supply. If not
contact an electrician.
Always use a correctly installed shockproof
socket.
Do not use multi-plug adapters and extension
cables.
Make sure not to cause damage to the electrical
components (e.g. mains plug, mains cable,
compressor). Contact the Service or an
electrician to change the electrical components.
The mains cable must stay below the level of
the mains plug.
Connect the mains plug to the mains socket
only at the end of the installation. Make sure
that there is access to the mains plug after the
installation.
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
Use
Warning! Risk of injury, burns,
electrical shock or fire.
Do not change the specification of this
appliance.
Do not put electrical appliances (e.g. ice cream
makers) in the appliance unless they are stated
applicable by the manufacturer.
Be careful not to cause damage to the
refrigerant circuit. It contains isobutane
(R600a), a natural gas with a high level of
environmental compatibility. This gas is
flammable.
If damage occurs to the refrigerant circuit, make
sure that there are no flames and sources of
ignition in the room. Ventilate the room.
Do not let hot items to touch the plastic parts
of the appliance.
Do not store flammable gas and liquid in the
appliance.
Do not put flammable products or items that
are wet with flammable products in, near or on
the appliance.
Wine cellar User Manual
5