User manual

Problem
1)
Possible cause Remedy
Abnormally elapsing
time on the display.
The time to end is calculated on the basis
of the volume and dampness of the laun-
dry.
The automatic procedure — this is not the
appliance malfunction.
Programme inactive.
The water container is full. Drain the water container, push the Start/
Pause button.
3)
Drying cycle too
short.
Too small laundry volume. Do the selection of time programme. The
time value must be related to the load. To
dry 1 item or small quantities of the laundry
we recommend to use short times.
The laundry is too dry. Do the selection of time programme or
higher drying level (e.g. Extra Dry)
Drying cycle too
long
6)
The filter is clogged. Clean the filter.
Too high volume of the load. Obey the maximum load volume.
The laundry not spun sufficiently. Spin correctly the laundry.
Very high room temperature - this is not
the appliance malfunction.
If possible, lower the room temperature.
1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on. Make a selection of the new pro-
gramme. Push the Start/Pause button. Does not operate? - contact the service centre and give the error code.
2) Follow the programme description — see PROGRAMME TABLE
3) See chapter CARE AND CLEANING
4) Only dryers with the Dry plus option
5) See HINTS AND TIPS chapter
6) Note: After maximum 5 hours the drying cycle ends automatically.
Tumble Dryer User Manual 27