User manual

Hints and tips
Ecological hints
• Spin good the laundry before drying.
• Use the load volumes which are specified in the
programme chart.
• Clean the filter after each drying cycle.
• Do not use fabric softener to wash and then
dry. In the tumble dryer laundry becomes soft
automatically.
• Use the condensate as distilled water, e.g. for
steam ironing. If it is necessary clean the
condensate before (e.g. with a coffee filter) to
remove possible small pieces of fluff.
• Always keep the airflow slots on the bottom of
the appliance clear.
• Make sure that is good airflow in the appliance
installation position.
Adjustment of the remaining
laundry moisture degree
To change the default degree of the remaining
moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold down the Dry
plus and Anti-crease buttons.
One of the symbols goes into the view on the
display:
- the maximum dry laundry
- the more dry laundry
- the default dry laundry
5. Push the Start/Pause button again and again
until you set necessary level.
6. To memorise the setting, push at the same
time the Dry plus and Anti-crease buttons
for approximately 2 seconds.
Deactivating the Tank
indicator:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold down the Dry
Plus and Alarm buttons.
One of 2 configurations are possible:
• the Tank indicator is on and the symbol
goes into the view - the water
container indicator is permanently on
• the Tank indicator is off and the symbol
goes into the view - the water
container indicator is permanently off
Tumble Dryer User Manual
21