User manual

Hints and tips
Ecological hints
• Do not use fabric softener to wash and then
dry. In the tumble dryer laundry becomes soft
automatically.
• Use the condensate as distilled water, e.g. for
steam ironing. If it is necessary clean the
condensate before (e.g. with a coffee filter) to
remove possible small pieces of fluff.
• Always keep the airflow slots on the bottom
of the appliance clear.
• Use the load volumes which are specified in
the programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the primary filter after each drying
cycle.
• Clean the heat exchanger filters when the
applicable indicator comes into the view on
the control panel.
• Spin good the laundry before drying.
Water hardness and conductivity
Water hardness can be different for different
locations. Water hardness has an effect on the
water conductivity and the operation of the
conductivity sensor in the appliance. If you know
the value of the water conductivity you can adjust
the sensor to dry with the better results.
To change the sensor conductivity:
1. Turn the programme dial to available
programme.
2. Push at the same time 2 buttons (see the
illustration). Hold down until one of the
symbols come into view on the display:
–
low conductivity <300 µS/cm
–
moderate conductivity 300-600
µS/cm
–
high conductivity >600 µS/cm
3. Push the button again and again until you
set necessary level (see the illustration).
4. To memorise the setting push at the same
time 2 buttons as are specified in the point
2.
Water container full — indication
By default the indication is always on. It comes
into the view at the end of the cycle or when the
water container is full. When you use an external
equipment to drain the container, the indication
can be off.
To activate or deactivate the indication:
1. Turn the programme dial to available
programme.
Tumble Dryer user manual 17