JLTDC11 Condenser dryer with heat pump Instruction manual
Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.
• Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. • If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. • After having installed the appliance, check that it is not pressing or standing on its electrical supply cable. • If the tumble dryer is placed on top of a washing machine, it is compulsory to use the stacking kit (optional accessory).
– Ensure you have good ventilation in the installation room; – Clean the micro-fine filter and fine strainer after each drying cycle; – Spin the laundry well before drying. • Fabric softeners, or similar products should be used as specified by the fabric softener instructions. • Caution - hot surface : Do not touch the door light cover surface when the light is switched on. (Only dryers equipped with internal drum light) Energy consumption depends on spinning speed set in washing machine.
detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product. product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
Contents For the user For the installer Important safety information 2 Technical specifications 23 Description of the appliance 24 24 24 25 25 27 Installation 7 Control panel 8 Before first use 8 Programme chart 9 Transporting the appliance Appliance positioning Removing transport safety packaging Electrical connection Door reversal Sorting and preparing laundry 10 Repairs - after sales service Daily use 11 Switching machine on Door opening and laundry loading Selecting the programme Extra de
Description of the appliance 1 2 3 4 5 6 8 7 9 11 10 12 1 2 3 4 5 6 Control panel Water reservoir Drum light Fine fluff filter Fluff filter Loading door (reversible) 7 8 9 10 11 12 7 Rating plate Course fluff filter Heat exchanger cover Push button for base door opening Ventilation grille Adjustable feet
Control panel 1 1 2 3 4 5 6 2 3 4 5 6 7 8 9 10 7 Display ( Dry time ) 8 Start/Pause button 9 Warning lights: Condenser , Filter , Full tank 10 Delay start button Programme selector and Off switch Extra delicate button Intensive button Anti-crease button Alarm button Time button Before first use In order to remove any residues which may have been produced during production, wipe the dryer drum with a damp cloth or carry out a brief drying cycle (30 MIN) with damp cloths in the machine.
Programme chart Programmes max. load (weight when dry) Extra delicate Intensive Anti-crease Alarm Time Delay start Additional functions/options Cottons Extra dry 7 kg - • • • - • Thorough drying of thick or multi- layered fabrics, e.g. terry towelling items, bathrobes, cottons. Cottons Store dry 7 kg - • • • - • Thorough drying of thick fabrics, e.g. terry towelling items, towels, cottons.
Delay start Time Alarm Intensive Anti-crease Extra delicate max. load (weight when dry) Programmes Additional functions/options Application/properties Wool care 1 kg - - - • - For briefly treating woollens with warm air, after they have been dried naturally, worn or stored for • long periods. Wool becomes soft and cosy. Recommendation: remove fabrics immediately after drying. Refresh 1 kg - - • • - • For refreshing or airing clothing that has been in storage.
Daily use Switching machine on Selecting the programme Turn the programme selector to any programme. The machine switches on. When the loading door is open, the internal lamp illuminates the drum. Door opening and laundry loading 1. Open loading door: Push against the loading door (push point) Use the programme selector to set the programme you require. The estimated time to end of the programme appears in the LCD in h:mm format (hours:minutes).
removed at any time during the anti-crease phase. To deselect the function press the Anticrease button again. The LED above is off. Press the Anti-crease button. A 90 minute anticrease phase is set. The display now shows the anti-crease icon. If this additional function is selected, the anti-crease phase at the end of the drying cycle is lengthened by 60 minutes. The laundry can be removed at any time during the anti-crease phase. To deselect the function press the Extra delicate button again.
1. Turn the programme selector to the Time programme. The flashing 10' above the Time button is on. If the display is showing 20h and you press the button again, the time delay will be cancelled. The display will show 0'and then the duration of the selected programme. 3. To activate the delay timer, press the Start/Pause button. The amount of time remaining until the programme is set to start is continuously displayed (e.g. 15h, 14h, 13h, … 30' etc). 2.
Starting the programme Putting in extra items or taking items out before end of programme Press the Start/Pause button. The programme starts. The programme progress is shown by elapsing Dry time on LCD. 1. Open loading door. Warning! Laundry and drum can become hot. Risk of burns! 2. Load or remove laundry items. 3. Close loading securely. Lock must audibly lock. 4. Press the Start/Pause button to continue the drying cycle.
2. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use a damp hand for this purpose. (See “Maintenance and cleaning” chapter.) 3. Remove laundry. 4. Turn the programme selector to Off . The drying cycles are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anticrease phase.
6. Remove the fluff from fine filter. It is best to use a damp hand for this purpose. Clean the entire filter area 7. 4. Push down the unlock button on the large mesh filter. The large mesh filter pops up. 8. 5. The filter area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Remove fluff from the entire filter area.
2. 1. 2. Pour the condensed water out into a basin or similar receptacle. If the fine filter is not fitted, the large mesh filter will not snap into place and the loading door cannot be closed. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. Emptying the water reservoir 3. Slide the outlet connections in and refit the water reservoir.
Cleaning heat exchanger filters If the warning lamp Condenser lights, the heat exchanger fluff filters in the base of the appliance must be cleaned, i.e. after each 5 drying cycles. Both filters are located in the appliance base. Water can collect in the filter housing therefore it is normal for the heat exchanger fluff filters to become wet. 2. Pull the filter housing out of the base by the handle. Important! • Never operate the dryer without the fluff filters.
6. As necessary, approx. once every 6 months, remove the fluff from the heat exchanger using the sponge supplied. When doing this, please use rubber gloves. Tip: The fluff can be removed more easily if it is first dampened (e. g. with a laundry dampener) or with help of vacuum cleaner. Cleaning the drum Caution! Do not use abrasives or steel wool to clean the drum. Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum.
Clean operating screen and housing Caution! Do not use furniture cleaners or aggressive cleaning agents to clean the machine. Use a damp cloth to wipe down the operating screen and housing. What to do if ... Problem 1) Dryer does not work. Unsatisfactor y drying results. Possible cause Remedy Dryer not connected to mains supply. Loading door opened. Close loading door The Start/Pause button not pressed. Press the Start/Pause button. Incorrect programme set. Set suitable programme.
Drying cycle to short Drying cycle to long 5) Small laundry volume./Too dry laundry for selected programme. Select time programme or higher drying level (e.g. Extra dry). Fluff filters clogged. Clean fluff filters. To high loading volume. Respect max. loading volume. Laundry insufficiently spun. Spun adequately the laundry. Particularly high room temperature - no machine fault. Lower the room temperature if possible. 1) In case of error message on the LCD (e.g.
4. To memorize setting press simultaneously the Anti-crease and Start/Pause buttons or turn knob to Off position Adjusting the level of conductivity Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle.
Technical specifications This appliance conforms with the following EU Directives: – 2006/95/EC dated 12.12.2006 Low Voltage Directive – 89/336/EEC dated 03.05.1989 EMC Directive inclusive of Amending Directive 92/31/EEC – 93/68/EEC dated 22.07.1993 CE Marking Directive Height x width x depth 85 x 60 x 58 cm Drum volume 108 l Depth with loading door open 109 cm Height can be adjusted by 1.5 cm Weight when empty approx. 57,5 kg Loading volume (depends on programme)1) max.
Installation • Air must be able to circulate freely all round the appliance. Do not obstruct the front ventilation grille or the air intake grilles at the back of the machine. • To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface. • Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is. • The feet must never be removed.
Important! • The appliance should not be installed in an environment such as a unheated garage or outbuilding. The combination of high humidity and low ambient temperatures could affect the performance or the appliance and therefore invalidate your guarantee. • The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance must therefore not be installed on floors which are not resistant to high temperatures.
If you fit your own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug. Proceed as follows: 1. Connect the Green and Yellow (earth) wire to the terminal in the plug which is marked with the letter "E" or the earth symbol or coloured green and yellow. 2. Connect the Blue (neutral) wire to the terminal in the plug which is marked with the letter "N" or coloured black. 3.
between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations. The switch must not break the yellow and green earth cable at any point. Warning! The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Centre.
even if the appliance is under guarantee. Spare parts Always insist on genuine spare parts. An authorised service engineer should service this product, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local John Lewis branch.
John Lewis Partnership 171 Victoria Street London SW1E 5NN www. johnlewis.