JLTDC10 Condenser dryer with heat pump Instruction manual
Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.
• If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely. • After having installed the appliance, check that it is not pressing or standing on its electrical supply cable. • If the tumble dryer is placed on top of a washing machine, it is compulsory to use the stacking kit (optional accessory). • Risk of fire: items that have been spotted or soaked with vegetable or cooking oil constitute a fire hazard and should not be placed in the tumble dryer.
• Caution - hot surface : Do not touch the door light cover surface when the light is switched on.1) Energy consumption depends on spinning speed set in washing machine. Higher spinning speed - lower energy consumption. Child safety Environmental information • This machine is not intended for use by young children or infirm persons without supervision. • This appliance is designed to be operated by adults. • Children should be supervised to ensure that they do not play with the appliance.
detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product.
Contents For the user For the installer Important safety information 2 Technical specifications 24 Description of the appliance 25 25 25 26 26 27 Installation 7 Control panel 8 Before first use 8 Programme chart 9 Transporting the appliance Appliance positioning Removing transport safety packaging Electrical connection Door reversal Sorting and preparing laundry 11 Repairs - after sales service Daily use 11 Switching machine on Door opening and laundry loading Selecting the programme Extra de
Description of the appliance 1 2 3 4 5 6 8 7 9 11 10 12 1 2 3 4 5 6 Control panel Water reservoir Drum light Fine fluff filter Fluff filter Loading door (reversible) 7 8 9 10 11 12 7 Rating plate Course fluff filter Heat exchanger cover Push button for base door opening Ventilation grille Adjustable feet
Control panel 1 1 2 3 4 5 6 2 3 4 5 6 7 8 9 10 7 Display (Dry time) 8 Start/Pause button 9 Warning lights: Condenser, Filter, Full tank 10 Delay start button Programme selector and Off switch Extra delicate button Intensive button Long anti-crease button Alarm button Time button Before first use In order to remove any residues which may have been produced during production, wipe the dryer drum with a damp cloth or carry out a brief drying cycle (30 MIN) with damp cloths in the machine.
Programme chart Programmes max. load (weight when dry) Extra delicate Intensive Long anti-crease Alarm Time Delay start Additional functions/options Cottons Extra dry 7 kg - • • • - • Thorough drying of thick or multi- layered fabrics, e.g. terry towelling items, bathrobes, cottons. Cottons Store dry 7 kg - • • • - • Thorough drying of thick fabrics, e.g. terry towelling items, towels, cottons.
Alarm Time Delay start - Intensive 1 kg Long anti-crease Extra delicate Refresh max. load (weight when dry) Programmes Additional functions/options - • • - • Application/properties For refreshing or airing clothing that has been in storage. Wool 1 kg - • - • - For drying woollen fabrics after they have been washed, using warm air at minimum mechanical load (Follow section “Sorting and preparing • washing”).
Sorting and preparing laundry • Do not dry cotton jersey and knitwear with the Extra programme. Items may shrink! • Wool and wool-like textiles can be dried using the Wool programme. Before the drying cycle spin the woollen textiles as well as possible (max. 1200 rpm). Only dry woollen textiles together of similar or the same material, colour and weight. Please dry heavy laundry items made of wool separately.
During the cycle time elapses by steps of one minute; less than 1 hour the leading zero is not shown (e.g. “59”, “5”, “0”). Extra delicate Extra delicate cycle is a programme specially designed for drying sensitive fabrics with the care label and for temperature-sensitive textiles (e.g. acrylic, viscose). The programme is executed with reduced heat. To activate it: 1. Choose the drying programme. 2. Load your laundry (do not force it in).
– When the anti-crease phase starts or ends – When the cycle is interrupted To activate it: 1. Choose the drying programme. 2. Press the Alarm button - the LED above is on. To deselect the function press the Intensive button again. The LED above is off. Long anti-crease This function prolongs the anti-crease phase to 90 mins in total. The drum rotates in intervals during this phase. The laundry therefore remains relaxed and free of creases. To activate it: 1. Choose the drying programme. 2.
Delay start – Before programme is started: Appliance cannot be used – After programme is started: Programme in operation cannot be changed The icon appears in the display to indicate that the child safety device is activated. With the Delay start button, you can delay the start of a programme by between 30 minutes (30') and a maximum of 20 hours (20h). 1. Select the programme and additional functions. 2.
signal sounds intermittently for about one minute. The programme can no longer be changed directly once the programme has started. If nevertheless there is an attempt to change the programme on the programme knob, the programme progress display and the maintenance indicators flash. If an option button (excluding the Alarm button) is pressed, Err appears in the multidisplay. The drying cycles (except from the Wool programme) are automatically followed by an anti-crease phase which lasts around 30 minutes.
Maintenance and cleaning Cleaning fluff filter The filters collect all the fluff which accumulates during drying. To ensure that the dryer works perfectly, the fluff filters (microfine filter and fine strainer) must be cleaned after every drying cycle. The warning lamp Filter lights to remind you of this operation at the end of each cycle. Caution! Never operate the dryer without fluff filters or with damaged or blocked fluff filters. 1. 2.
9. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. 10. Re-insert fine filter. 11. Press against the large mesh filter until it locks into the interlock. 6. Remove the fluff from fine filter. It is best to use a damp hand for this purpose. Clean the entire filter area 7. The filter area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary.
1. Take out drawer containing water reservoir completely 1 and pull up the water reservoir's drainage pipe as far as it will go 2. The condensed water can be used as distilled water, e.g. for steam ironing. However it must first be filtered (e.g. with a coffee filter) to remove any residue and small pieces of fluff. 2. Cleaning heat exchanger filter If the warning lamp Condenser lights, the heat exchanger filter in the base of the appliance must be cleaned. 1.
2. Pull the filter housing out of the base by the handle. 1 2 1 3. 4. 5. Clean the inside of the door, the fluff filter chamber and the rubber seals of fluff. Remove fluff from the fluff filter on the floor of the base with a damp hand. To clean the fluff filter: Remove the filter from the filter housing. To do this, press the pressure points on the sides and pull the filter frame up and out of the housing. 19 6. Remove fluff from the fluff filter with a damp hand.
Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the dryer. Use a standard domestic cleaner (e.g. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Clean operating screen and housing The fluff can be removed more easily if it is first dampened e. g. with a laundry dampener.
What to do if ... the error is still displayed, please inform your local Service Force Centre and quote the error code. If, during operation, the error code E... plus number or letter) appears on the LCD: Switch the machine off and on again to reset the programme. Press the Start/Pause button If Problem Dryer does not work. Drying results unsatisfactory. Possible cause Remedy Mains plug is not plugged in or fuse is not working correctly. Plug in at mains socket.
Displayed programme time changes erratically or stays unchanged for a long time. Programme time is corrected automatically depending on type Automatic process; this is not a and volume of laundry and level machine fault. of dampness. Programme inactive, empty water tank warning lamp Full tank lights. The water reservoir is full. Empty the water reservoir, then start programme with Start/ Pause button. Drying cycle ends shortly after programme starts. END display illuminated.
Machine settings ALARM permanent on/off 2. Press simultaneously the Intensive and Long anti-crease buttons and hold down for approx. 5 seconds. The alarm is by default always off. To set permanent alarm on (off): 1. Turn the programme selector to any programme. Adjusting the level of conductivity 3.
Technical specifications This appliance conforms with the following EU Directives: – 2006/95/EC dated 12.12.2006 Low Voltage Directive – 89/336/EEC dated 03.05.1989 EMC Directive inclusive of Amending Directive 92/31/EEC – 93/68/EEC dated 22.07.1993 CE Marking Directive Height x width x depth 85 x 60 x 58 cm Drum volume 108 l Depth with loading door open 109 cm Height can be adjusted by 1.5 cm Weight when empty approx. 60 kg Loading volume (depends on programme)1) max.
Installation • Air must be able to circulate freely all round the appliance. Do not obstruct the front ventilation grille or the air intake grilles at the back of the machine. • To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface. • Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is. • The feet must never be removed.
Removing transport safety packaging Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Caution! Before use all parts of the transport packaging must be removed. Warning! THIS APPLIANCE MUST BE EARTHED. Should the appliance power supply cable need to be replaced, this must be carried out by a Service Force agent (see chapter: Repairs - after sales service).
Warning! The plug must still be accessible after the appliance has been installed. GREEN & YELLOW Warning! The appliance should not be connected to the electrical supply by means of an extension cable. Warning! The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Centre.
Please contact your nearest John Lewis branch who will give you details of your local Service Force Centre. The engineer will carry out the door reversal at your cost. Repairs - after sales service If the unlikely event of your appliance requiring service, or if you wish to purchase spare parts, please contact our extended warranty administrators by telephoning: 0870 010 7887 They will give you details of your local Service Force Centre.
John Lewis Partnership 171 Victoria Street London SW1E 5NN www. johnlewis.
