User manual

9
Operating Sequence
Before using your tumble dryer for the first time, we
recommend that you place a few damp cloths inside
the appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door (see picture).
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does not
get caught between the door and filter.
5. Select the drying programme or time. The lights
DRYING, COOLING and END come on. The
light of the START/PAUSE button flashes and the
display shows the duration of the programme.
6. If required, press the HALF POWER button
and/or the ALARM OFF button or the QUICK
button.
7. Select the DELAY START if required. The selected
delay appears on the display for 2 seconds, then
the duration of the selected programme is
displayed.
8. Press the START/PAUSE button: the
corresponding light stops flashing and drying
starts. Only the DRYING light stays lit. If you have
selected the DELAY START, the machine begins its
countdown.
If the programme selector dial is turned to
another position, when the machine is running, the
buzzer will sound, the programme phase indicator
lights will flash.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (COOLING light illuminates).
You may remove the laundry after this phase.
The lights END, FILTER and FULL TANK
illuminate and the buzzer sounds.
The display shows a static zero.
P1108
P1149
9. If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing phase
(duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will
stop automatically at the end of the anti-creasing
phase.
The END, FILTER and FULL TANK lights remain
lit and the buzzer sounds every 10 seconds for 2
minutes.
The light of the START/PAUSE button goes off and
a flashing zero appears on the display.
10.Turn the programme selector dial to “Off”; all the
lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the programme selector dial to
“Off”, all the lights corresponding to the
phases making up the performed
programme come on and the display shows
the duration of the programme.
After each use
● Clean the filters (see page 11).
● Empty the water reservoir (see page 12).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position “Cooling” and
wait until the end of this phase before removing the
laundry. This will avoid a build-up of heat inside the
appliance. To do this first turn the dial to “Off” and
then to “Cooling” and depress START/PAUSE
Button
.
Modifying the programme
To change a programme which is running, first cancel
it by turning the programme selector dial to “Off”.
Select the new programme and press the
START/PAUSE Button.