User manual

15
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and
mineral salts. Their quantities vary according to
geographical locations thus varying its conductivity
values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could
slightly influence the residual humidity of the laundry
at the end of the cycle.
Your dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity values of
the water by using the following procedure.
To establish the hardness of your water to
correspond with the table opposite please contact
your local water authority.
Procedure:
Turn the programme selector dial to switch on the
appliance
In selection mode press simultaneously the buttons
3 and 6 until «
CC00
» appears on the digits.
12345 6
1.25
Delay
startDoor Quick
Start/
Pause
Drying
Cooling
End
Filter
Full tank
Condenser
Dry time
JLTDCO5
Half
power
Alarm
off
Iron dry
Delicates
Synthetics
60 minutes
Extra dry
Off
Store dry
Cupboard dry
Damp dry
Iron dry
Machine iron dry
Extra dry
Cupboard dry
90 minutes
30 minutes
Cottons
Dry cleaning
Cooling 10 minutes
Adjusting the level of
conductivity:
Press the button 5 sequentially: the level of
conductivity is indicated by the lighting of the
horizontal hyphens.
Normally, the appliance is factory-set to the
highest level; however, certain models may be
configured differently.
Memorising the new setting:
Simultaneously press down the buttons 3 and 6 until
the previous drying cycle time appears again on the
display and the buzzer sounds.
12345 6
Delay
startDoor Quick
Start/
Pause
Drying
Cooling
End
Filter
Full tank
Condenser
Dry time
JLTDCO5
Half
power
Alarm
off
Display
Conductivity
degree
Approximative
value (µS/cm)
CC 00
Low < 300
CC 00
Medium 300 - 600
CC 00
High > 600