User manual

3. Remove foil hose and polystyrene padding
from the machine.
Electrical connection
Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
Warning! THIS APPLIANCE
MUST BE EARTHED.
Should the appliance power
supply cable need to be replaced,
this must be carried out by a
Service Force agent (see
chapter: Repairs - after sales
service).
The manufacturer declines any
liability should this safety
measure not be observed.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the appliance’s rating plate. (See picture on
page 6).
The appliance is supplied with a 13amp plug
fitted. In the event of having to change the fuse
in the plug supplied, a 13amp ASTA approved
BS 1363/A fuse must be used.
Should the plug need to be replaced for any
reason, proceed as described below. The
wires in the mains lead are coloured in
accordance with the following code:
• Green and Yellow - Earth
•Blue - Neutral
•Brown - Live
GREEN & YELLOW
BROWN
CORD CLAMP
BLUE
If you fit your own plug, the colours of the
wires in the mains lead of your appliance may
not correspond with the markings identifying
the terminals in your plug.
Proceed as follows:
1. Connect the Green and Yellow (earth)
wire to the terminal in the plug which is
marked with the letter "E" or the earth
symbol
or coloured green and yellow.
2. Connect the Blue (neutral) wire to the
terminal in the plug which is marked with
the letter "N" or coloured black.
21