User manual

Replacing the drum light
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local Service Force
Centre.
Important! When the appliance is switched
on, the interior lighting switches itself off after
4 minutes when the door is open.
Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
Warning! Before replacing the bulb,
disconnect the mains plug; with a
permanent connection: fully unscrew
or deactivate the fuse.
1. Unscrew the cover above the bulb (this
can be found directly behind the loading
aperture, at the top; refer to “Description
of machine” section.)
2. Replace the defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket
before screwing back the door light cover. Do
not operate the dryer when missing o-ring
gasket on door light cover.
Warning! For safety reasons, the
cover must be screwed down tightly.
If this is not done, the dryer must not
be operated.
Machine settings
Alarm permanent on/off
The alarm is by default always off. To set
permanent alarm on (off):
1. Turn the programme selector to any
programme.
2.
Press simultaneously the Half power and
Anti-crease buttons and hold down for
approx. 5 seconds.
Adjusting the level of
conductivity
Water contains, a variable quantity of
limestone and mineral salts of which
quantities vary according to geographical
locations thus varying its conductivity
values.
Relevant variations of the conductivity of
the water compared to those prefixed by
the factory could slightly influence the
residual humidity of the laundry at the
end of the cycle. Your dryer allows you to
regulate the sensitivity of the drying
sensor based on conductivity values of the
water.
In order to establish the conductivity of
the water in your area please contact
your water board.
17