User manual

Maintenance and cleaning
Cleaning fluff filter
The filters collect all the fluff which
accumulates during drying. To ensure that the
dryer works perfectly, the fluff filters (micro-
fine filter and fine strainer) must be cleaned
after every drying cycle.
The warning lamp Filter lights to remind you
of this operation at the end of each cycle.
Caution! Never operate the dryer
without fluff filters or with damaged or
blocked fluff filters.
1. Open loading door
2. Use a damp hand to clean the micro- fine
filter, which is built into the lower part of
the loading aperture.
3. After a period of time, a gleam due to
detergent residue on laundry forms on the
filters. When this occurs, clean the filters
with warm water using a brush. Remove
the filter from the door pulling it out. (It
can be positioned with the locating spur
facing to the left or to the right).
After cleaning do not forget to put it back.
4. Take out fine filter. Remove the fluff. It is
best to use a damp hand for this purpose.
5. Re-insert fine filter.
Cleaning the door seal
Wipe the door seal with a damp cloth
immediately after the drying cycle has finished.
Emptying the water
reservoir
Empty the water reservoir after every drying
cycle.
If the water reservoir is full, an active
programme will break off automatically and
the warning lamp Full tank lights. In order to
continue the programme, the water reservoir
must first be emptied.
13