User manual

Changing programme
To change a programme which has been
selected by mistake once the programme has
started, first turn the programme selector to
Off and then reset the programme.
The programme can no longer be
changed directly once the programme
has started.
Putting in extra items or
taking items out before
end of programme
1. Open loading door.
Warning! Laundry and drum can
become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audibly
lock.
4. Press the Start/Pause button to continue
the drying cycle.
Drying cycle complete /
removing laundry
Once the drying cycle is complete, the LED
End is on as well as warning lamps: Filter and
Full tank . If the Alarm button has been pressed,
an acoustic signal sounds intermittently for
about one minute.
The drying cycles are automatically
followed by an anti-crease phase
which lasts around 30 minutes. The
drum rotates at intervals during this
phase. This keeps the laundry loose
and free of creases. The laundry can be
removed at any time during the anti-
crease phase. (The laundry should be
taken out towards the end of the anti-
crease phase at the latest to prevent
creases from forming.) If Anti-crease
function has been selected, the anti-
crease phase is lengthened by 60
minutes.
1. Open door.
2. Before removing the laundry, remove fluff
from the micro-fine filter. It is best to use
a damp hand for this purpose. (See
“Maintenance and cleaning” chapter.)
3. Remove laundry.
4. Turn the programme selector to Off .
Important! After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter “Maintenance and
cleaning ”.)
5. Close the door.
12