User manual

Problem Possible cause Solution
The compressor does not start im-
mediately after pressing the Fast-
Freeze, or after changing the tem-
perature.
This is normal, no error has oc-
curred.
The compressor starts after a period
of time.
Water flows inside the refrigerator. The water outlet is clogged. Clean the water outlet.
Food products prevent that wa-
ter flows into the water collector.
Make sure that food products do not
touch the rear plate.
Water flows on the floor. The melting water outlet is not
connected to the evaporative
tray above the compressor.
Attach the melting water outlet to the
evaporative tray.
Temperature cannot be set. The FastFreeze or Shopping-
Mode function is switched on.
Switch off FastFreeze or Shopping-
Mode manually, or wait until the func-
tion resets automatically to set the
temperature. Refer to "FastFreeze or
ShoppingMode function".
Door is misaligned or interferes
with ventilation grill.
The appliance is not levelled. Refer to "Levelling".
The temperature in the appliance is
too low/too high.
The temperature regulator is not
set correctly.
Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The food products' temperature
is too high.
Let the food products temperature
decrease to room temperature be-
fore storage.
Many food products are stored at
the same time.
Store less food products at the same
time.
The door has been opened often. Open the door only if necessary.
The FastFreeze function is
switched on.
Refer to "FastFreeze function".
There is no cold air circulation in
the appliance.
Make sure that there is cold air circu-
lation in the appliance.
If the advice does not lead to the
desired result, call the nearest
brand-mark service.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
Fridge Freezer User Manual14