User manual

Problem Possible cause Remedy
The display shows an error code
that is not in this table.
There is an electrical fault. • Deactivate the oven with the
house fuse or the safety switch
in the fuse box and activate it
again.
• If the display shows the error
code again, contact the Cus-
tomer Care Department.
Steam and condensation settle on
the food and in the cavity of the
oven.
You left the dish in the oven for too
long.
Do not leave the dishes in the oven
for longer than 15 - 20 minutes af-
ter the cooking process ends.
The appliance is activated and does
not heat up. The fan does not oper-
ate. The display shows "Demo".
The demo mode is activated. Refer to "Basic Settings" in "Daily
use" chapter.
The appliance does not retain the
water drawer after you insert it.
You did not assemble the lid of the
water drawer correctly.
Assemble the lid of the water draw-
er correctly.
Water comes out of the water
drawer after you carry it or put it
inside the appliance.
You did not assemble the lid of the
water drawer correctly.
Assemble the lid of the water draw-
er correctly.
Water comes out of the water
drawer after you carry it or put it
inside the appliance.
You did not assemble the wave-
breaker correctly.
Assemble the wave-breaker in the
body of the water drawer correctly.
The appliance does not retain the
water drawer after you push it on
the cover.
You did not fully press the water
drawer body.
Insert the water drawer body in the
appliance by pushing it until it rea-
ches to the end.
The water drawer is difficult to
clean.
You did not remove the lid and the
wave-breaker.
Refer to "Cleaning the water draw-
er".
The descaling procedure is inter-
rupted before it finishes.
There was a power cut. Repeat the procedure.
The descaling procedure is inter-
rupted before it finishes.
The function was stopped by the
user.
Repeat the procedure.
There is no water inside the grill- /
roasting pan after the descaling pro-
cedure.
You did not fill the water drawer to
the maximum level.
Check if the a descaling agent / wa-
ter is present in the water drawer
body.
Repeat the procedure.
There is dirty water on the bottom
of the cavity after the descaling cy-
cle.
The grill- / roasting pan is on a
wrong shelf position.
Remove the residual water and the
descaling agent from the bottom of
the oven. Put the grill- / roasting
pan on the first shelf position.
Steam oven User Manual 71