User manual
Installation
Important! For electrical connection
carefully follow the instructions given in
specific paragraphs.
• Unpack the appliance and check if there are
damages on it. Do not connect the appliance
if it is damaged. Report possible damages
immediately to the place you bought it. In that
case retain packing.
• It is advisable to wait at least four hours
before connecting the appliance to allow the
oil to flow back in the compressor.
• In order to prevent over heating there must
be adequate circulation around the appliance.
• Please refer to the correct positioning and
location instructions that can be found in the
Installation section of this user guide.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
Service
• Any electrical work required to do the
servicing of the appliance should be carried
out by a qualified electrician or competent
person.
• This product must be serviced by an
authorized Service Centre, and only genuine
spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,
in either its refrigerant circuit or
insulation materials. The appliance shall
not be discarded together with the
urban refuse and rubbish. The
insulation foam contains flammable
gases: the appliance shall be disposed
according to the applicable regulations
to obtain from your local authorities.
Avoid damaging the cooling unit,
especially at the rear near the heat
exchanger. The materials used on this
appliance marked by the symbol
are recyclable.
Freezer user manual 5