User manual

2. Install the spacer.
3. Install the door.
4. Tighten the upper pin.
Installing the appliance
Caution! Make sure that the
mains cable can move freely.
Do the following steps:
1. If necessary cut the adhesive sealing strip
and then apply it to the appliance as shown
in figure.
X
X
2. Drill the unit using a Ø 2.5 mm drill (10 mm
max. penetration).
Fix the square fitting to the appliance.
13mm
2,5
3. Install the appliance in the niche.
Push the appliance in the direction of the
arrows (1) until the upper gap cover stops
against the kitchen furniture.
Push the appliance in the direction of the
arrows (2) against the cupboard on the
opposite side of the hinge.
Freezer user manual 19