User manual

10
Place guide (Ha) on the inside part of the furniture
door, up and down as shown in the figure and mark
the position of external holes.After having drilled
holes, fix the guide with the screws supplied.
Fix cover (Hc) on guide (Ha) until it clips into place
PR33
Hc
Ha
PR266
Ha
Hb
Hc
Hd
Separate parts Ha, Hb, Hc, Hd as shown in the
figure.
2
1
m
m
ca. 50 mm
90°
ca. 50 mm
2
1
m
m
Apply covers (C-D) on joint cover lugs and into
hinge holes.
Snap vent grille (B) and hinge covers (E) into
position.
B
E
E
D
C
From the plastic cover (E), which is used to cover
the hinge with the pivot pin, you must take away the
part as indicated in the drawing.
This operation is made easer since there is, in the
internal part of the cover hinge lid a groove that
facilates the removal of this coomponent.
“Remove the part marked with DX, if the pivot pin
is inserted in the right hinge, SX in opposite case.”