JLBIFIC02 Built-in freezer Instruction manual John Lewis Partnership 171 Victoria Street London SW1E 5NN www.johnlewis.
Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.
Repairs - After Sales Service Environmental Information • After installation, please dispose of the packaging with due regard to safety and the environment. This product should be serviced by an authorised service engineer, and only genuine spare parts should be used. • When disposing of an old appliance, make it unusable, by cutting off the cable. Remove any door catches, to prevent small children being trapped inside. Under no circumstances should you attempt to repair the appliance yourself.
Something not working Contents For the User For the Installer Important Safety Information 2 Installation 6 Description of the appliance 5 Technical Specification 6 Control panel 12 Electrical Connection 6 When the Freezer is first installed 12 Positioning 7 Activation of functions 12 Building In 8 Switching off 12 If the appliance is not working correctly, please carry out the following checks, before contacting your local Service Force repair agent.
Maintenance and Cleaning Description of the Appliance Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. 1 Internal cleaning Defrosting Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly. Freezer NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHLY PERFUMED CLEANING PRODUCTS OR WAX POLISHES,TO CLEAN THE INTERIOR AS THESE WILL DAMAGE THE SURFACE AND LEAVE A STRONG ODOUR.
Installation Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable.
Excessive temperature alarm An increase in the temperature in the freezer compartment (for example due to an electricity outage) is indicated by: - flashing temperature; - freezer compartment flashing (symbol 2); - red illumination of display; - sounding of buzzer. - alarm symbol. When normal conditions are restored: - the acoustic signal shuts off; - the temperature value continues to flash; - the display illumination remains red.
Using the freezer Building In Before use Before carrying out any work, remove the plug from the power socket. Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. Remove all securing tapes.Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly.
The Control Panel Drill the unit using a Ø 2.5 mm drill (10 mm max. penetration); Mode On / Off 1 2 5 4 B A Ø 2,5 Fix the square fitting to the appliance. C 3 D 13mm Push button A- Appliance button ON/OFF C- Function button B- Temperature and function indicator D- Thermostat control knob D740 DISPLAY 1 1. 2.
Apply covers (C-D) on joint cover lugs and into hinge holes. Snap vent grille (B) and hinge cover (E) into position. Should the lining up of the furniture door be necessary, use the clearance of slots. D C At the end of operations, it is necessary to check if the door of the furniture closes properly. E Hb B PR168 Fix cover (Hd) on guide (Hb) until it clips into place. Separate parts Ha, Hb, Hc, Hd as shown in the figure. Hb Ha Hb Hc Hd Hd PR266 PR167/1 ca.
