User manual

Problem Possible cause Solution
Many food products were put in
at the same time.
Wait few hours and then check the
temperature again.
The room temperature is too
high.
Refer to climate class chart on the rat-
ing plate.
Food products placed in the ap-
pliance were too warm.
Allow food products to cool to room
temperature before storing.
The door is not closed correctly. Refer to "Closing the door".
Water flows inside the refrigerator. Food products prevent the water
to flow into the water collector.
Make sure that food products do not
touch the rear plate.
The water outlet is clogged. Clean the water outlet.
Water flows on the floor. The melting water outlet is not
connected to the evaporative
tray above the compressor.
Attach the melting water outlet to the
evaporative tray.
dEMo appears on the display. The appliance is in demonstration
mode.
Keep the OK pressed for approxi-
mately 10 seconds until a long sound
is heard and display shuts off for a
short time.
The temperature in the appliance is
too low/too high.
The temperature regulator is not
set correctly.
Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The food products' temperature
is too high.
Let the food products temperature
decrease to room temperature be-
fore storage.
Many food products are stored at
the same time.
Add less food products at the same
time.
The door has been opened often. Open the door only if necessary.
There is no cold air circulation in
the appliance.
Make sure that there is cold air circu-
lation in the appliance.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
Closing the door
1. Clean the door gaskets.
Fridge Freezer User Manual20