User Guide

Like our Standard Fittings, Twist and Lock Fittings have a collet
with stainless steel teeth that grip the pipe when fully inserted, and
an O-ring to provide a permanent leak-proof seal. The additional
benefit of the Twist and Lock fitting is that a twist of the screw-cap
gives greater compression on the O-ring seal and locks the pipe
in place for greater security.
PREPARE THE PIPE
To prevent damage to the O-ring remove all burrs and sharp
edges. When using Speedfit Pipe, we recommend the use of a
Pipe Insert. The insert should only be used with Speedfit Pipe.
HOW TO MAKE A CONNECTION
Fittings and pipe should be kept clean, bagged, and undamaged
before use.
TWIST AND LOCK FITTINGS
The fitting should be in the ‘unlocked’ position. This is shown by a
small gap between the screw-cap and the body flange.
Push the pipe into the fitting and up to the pipe stop.
Twist the screw-cap until it touches the body flange.
This locks the pipe into position and increases the
o-ring seal around the pipe.
Pull to check that it is secure. It is good practice to test the system
prior to leaving the site or before use. Our recommended test
procedure is shown in our Technical Checklist.
TO DISCONNECT:
Ensure that the system is depressurized.
Be sure to twist the screw-cap back to the unlock position.
Push the collet square against the face of the fitting by using
fingers. With the collet held in this position the pipe can be
removed.
The fitting can be used again without the need for replacement
parts. (Ensure the fitting is clean before every use).
WHAT NOT TO DO
• Do not use damaged or scored pipe
• Do not use a hacksaw to cut the pipe
• Do not leave burrs on the end of the pipe
• Do not forget to push the pipe fully into the tting, past both
the collet (gripper) and the O-ring.
• Do not insert ngers into the tting as the stainless steel teeth
may cause injury.
Remember to pressure test the completed installation according
to the recommendations in our Technical Checklist.
Speedfit Pipe
PipeCutter
JGHDC
Pipe Stop O-ring Collet
Spacer
Gap between Cap and Flange (unlocked)
No Gap (locked)
MAKING A GOOD CONNECTION
3.
Main O-ring Stainless Steel Teeth
grip the pipe
Pipe insert provides
a secondary seal
Spacer