Installation Guide

5
5
If you are not using collet clips, ensure that the screwcaps
are in the locked position. Pull to check it is secure.
It is good practice to test the system prior to leaving
the site or before use. Our recommended test procedure
is shown in our Technical Checklist.
Twist the screwcap until it touches the body flange.
This increases the O-Ring seal around the pipe and
locks the pipe into position.
Standard Speedfit connections are made in the same
way as Twist & Lock.
Push pipe up to Pipe Stop. If the Speedfit pipe has
been cut correctly the insertion mark on the pipe
will be level with the collet head.
Pull to check connection is secure and test the system.
Our recommended test procedure is shown in our
Technical Checklist on page 23.
Standard Speedfit fittings
Pipe mark
indicates
full insertion
Push pipe up to
stop
Secondary
seal
Main O-Ring