Installation Guide

13
Cut pipe square using pipe cutters
remove burrs and sharp edges.
Pull to check the system is secure then test
the system to ensure it is water tight.
Always use a Speedfit Pipe Insert,
which must be fully inserted.
Ensure the system is depressurised. Remove
the collet cover by sliding it along the pipe.
Squeezing the raised portions will aid removal.
Push the collet square against the fitting.
With the collet held in this position, the pipe
can be withdrawn.
1
5
4
6
Pipe insert
2
Push the pipe into the fitting, up to the pipe stop.
The stainless steel teeth grip the pipe, the O-Ring
provides a permanent leakproof seal.
3
O-Ring Collet teeth
Pipe stop
To disconnect
Cold water services
- making a good connection