Operator's Manual
Table Of Contents
- Introduction
- Safety
- Recognize Safety Information
- Understand Signal Words
- Follow Safety Instructions
- Practice Safe Maintenance
- Use Steps and Handholds Correctly
- Handle Electronic Components and Brackets Safely
- Use Electronic Display Properly
- Prevent Electrical Shock and Fires
- Avoid Exposure to High Radio Frequency Fields
- Remote Controls
- Regulatory and Compliance Information
- System Overview
- Component Overview
- Setting Up—GreenStar™ 3 2630 Display
- Setting Up—Generation 4 Display
- Operating
- Operating–Managing Data On Wireless Data Server
- Operating–Updating Software
- Operating–Resetting Wireless Password
- Troubleshooting
- Maintenance
- Index
- John Deere Service Literature Available
- John Deere Service Keeps You On Job
PROOF PROOF
Notications to User
These devices must be operated as supplied by John
Deere Ag Management Solutions. Any changes or
modications made to these devices without the
express written approval of John Deere Ag
Management Solutions may void the user’s authority to
operate these devices.
BA31779,00006FC-19-25OCT13
Federal Communications Commission
(FCC) Notications to User
Wireless Data Server
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment o and on, the user is
encouraged try to correct the interference by one or
more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and
receiver.
HC94949,0000F5A-19-28MAR19
Regulatory and Compliance Information
20-1