Operator's Manual

PROOF PROOF
aid the operator in performing eld operations, increase
comfort and provide entertainment. Displays o󰀨er a
wide range of functionality, are used in many di󰀨erent
machine system applications and can be used with
other secondary devices such as handheld electronic
devices.
A secondary device is any device that is not required to
operate your machine for its primary use. The operator
is always responsible for safe operation and control of
the machine.
To prevent injury while operating the machine:
● Position the display according to the installation
instructions. Ensure that the device is secured and
does not obstruct the driver’s view or interfere with
the machine operating controls.
● Do not become distracted by the display. Stay alert.
Pay attention to the machine and surrounding
environment.
● Do not change settings or access any functions that
require prolonged use of the display controls while
machine is moving. Stop the machine in a safe
location and place in park position before attempting
such operations.
● Never set the volume so high that you cannot hear
outside tra󰀩c and emergency vehicles.
To promote safe operation, certain functions of displays
may be disabled unless the machine movement is
restricted and/or has been placed in the park position.
Overriding this safety feature may violate applicable law
and can result in damage, serious injury, or death.
Only use available display functionality when conditions
permit you to do so safely and in accordance with
instructions provided. Always observe safe driving rules,
state, or local laws and tra󰀩c regulations when using
any secondary device.
DX,ELEC,DISPLAY-19-13JAN15
Prevent Electrical Shock and Fires
PC12631—UN—04JUN10
Battery-powered equipment or other electric power
sources produce an electrical shock, sparks, or arcs if a
short circuit occurs. Electrical short circuits can reach
temperatures high enough to burn people, or ignite or
melt common materials.
To prevent injury from electrical shock, burns, or
potential re hazards, always disconnect battery power
or other electric power source on equipment before
installing or servicing:
● Remove ground (negative terminal [-]) battery clamp.
● Detach and remove battery.
● Switch o󰀨 main battery or other electric power
source.
● Unplug electric power source from equipment.
Understand and follow all local codes and regulations
when installing electrical equipment.
HC94949,0000487-19-27JAN14
Avoid Exposure to High Radio Frequency
Fields
PC12632—UN—04JUN10
Prevent injury from exposure to high radio frequency
elds at the antenna. Do not touch antenna while the
system is transmitting. Always disconnect power to the
antenna before installing or servicing.
The antenna should always be separated from the
operator or nearby persons by a minimum distance of
20 cm (8 in.).
JS56696,0000C0E-19-11DEC12
Remote Controls
Remote controls are intended to allow machine
operators to perform actions with the machine from a
location which is not a designated operator station.
Remote controls can be mechanical or electrical and
can be xed to the machine or wireless. The machine
operator is always responsible for safe operation and
control of the machine.
To prevent injury when using remote controls:
● If equipped, ensure any audible or visual signals that
indicate remote control machine operation are
functioning properly.
Safety
05-3