User Manual
Table Of Contents
- Contents
- Live With Safety
- Parts List
- Service Parts
- Parts Included In Kit
- Tools and Equipment
- Customer Support Center
- Customer Personal Service (CPS)
- Cellular Service
- Basic System Layout
- Selecting Mounting Location For Communications Controller
- Installing Communications Controller
- _
- Removing Communications Controller
- Installing Communications Controller Harness
- Installing Power Harness
- Selecting Mounting Location For Antennas
- Assembling Antennas Using Mounting Bracket
- Installing Antennas Through Machine Roof or Metal Panel
- System Testing
- Vehicle Hours Synchronization
- Problem Diagnosis
- Page Numbers
Installation Instructions
CED,TX13067,2532 –19–05OCT99–3/3
Symptom Problem
Solution
GPS antenna cable connection Check GPS antenna cable
connections at antenna and
communications controller.
Communications controller failure Replace antenna and cable. If LEDs
do not come ON and voltage checks
are OK, replace communications
controller.
GPS/ENG RUN LED Light Does Blown fuse Check W+/R+ Engine Running Fuse
Not Come ON (Engine Running) in Power Harness
Incorrect voltage or poor connection With engine running a minimum of 6
at engine running signal source volts must be present at W+/R+
Engine Running connection to
engine (Purple wire).
Power harness failure With engine running, check for a
minimum of 6 volts on Purple wire in
4-pin connector of power harness.
Communications controller harness With engine running, check for a
failure minimum of 6 volts on pin B-1
(Purple wire) in connector of
communications controller harness.
Communications controller failure If voltages are correct,
communications controller has failed.
DeereTrax (13APR00)
41
Installation Instructions
041300
PN=43
P R O O F P R O O F