User Manual

Installation Instructions

CED,TX13067,2532 –19–05OCT99–2/3

Symptom Problem

Solution

LED harness failure Check for battery voltage on both

Yellow wires in six-pin connector on

communications controller harness

as key is turned ON (Use the Black

wire in that connector as a ground

reference).

Voltage may fluctuate for five

seconds, but should remain constant

after that.

If voltage is present on yellow wires,

but LED lights aren’t ON, harness

has failed. replace harness.

Communications controller failure If voltages in previous checks are

correct, communications controller

has failed.

Cellular Connection LED Does Cellular antenna cable connection Check cellular cable connection at

Not Come ON antenna and communications

controller.

Cellular antenna failure Check general antenna condition.

Replace if damage is seen.

Lack of cellular service Assure cellular service is available,

call with a hand-held cellular phone

to be sure. Perform procedure to

activate cellular service. If service is

still not activated, call Customer

Support Center at 1-800-939-0805

Communications controller failure Replace antenna and cable. Verify

cellular phones will work in that

location. If LEDs do not come ON

and voltage checks are OK, replace

communications controller.

GPS/ENG RUN LED Light Does Obstructed view of sky Move machine to an open location

Not Come ON (Engine OFF) away from buildings and overhead

power lines.

GPS antenna failure Check general antenna condition,

replace if damage is seen.

DeereTrax (13APR00)

Installation Instructions

041300

PN=42

P R O O F P R O O F

Continued on next page