User Manual
Table Of Contents
- Contents
- Live With Safety
- Parts List
- Service Parts
- Parts Included In Kit
- Tools and Equipment
- Customer Support Center
- Customer Personal Service (CPS)
- Cellular Service
- Basic System Layout
- Selecting Mounting Location For Communications Controller
- Installing Communications Controller
- _
- Removing Communications Controller
- Installing Communications Controller Harness
- Installing Power Harness
- Selecting Mounting Location For Antennas
- Assembling Antennas Using Mounting Bracket
- Installing Antennas Through Machine Roof or Metal Panel
- System Testing
- Vehicle Hours Synchronization
- Problem Diagnosis
- Page Numbers
Installation Instructions
CED,TX13067,2532 –19–05OCT99–1/3
Problem Diagnosis
Symptom Problem
Solution
LED Lights Do Not Come ON Blown fuses Check fuses in power harness
When Key Is Turned ON
Connection to alternator incorrect Check harness connections to
terminals on alternator.
B+ unswitched power (Red Wire)
must be connected to positive (+)
power source.
GND (Black wire) must be
connected to clean frame ground.
D+ switched power (Brown Wire)
must be connected to positive (+)
power source. Voltage with key ON.
Power harness failure Check Brown wire in four-pin power
harness connector. It must have
voltage only when the key is ON.
Check Red wire in four-pin power
harness connector. It must have
voltage all the time.
Check Black wire in four-pin power
harness connector. It must have a
good connection to frame ground.
Communications controller harness Check pin 1A (Red wire) in
failure connector to communications
controller. It must have battery
voltage at all times.
Check pin A3 (Brown wire) for
battery voltage only when key is ON.
Check pin 2A (Black wire) for
continuity to frame ground.
DeereTrax (13APR00)
39
Installation Instructions
041300
PN=41
P R O O F P R O O F
Continued on next page